
Change or rekey · Tollendal
Lock Replacement & Upgrade in Tollendal
The house is fifteen years old and every exterior door still wears the light hardware the builder fitted: a short bolt, a thin strike held by two small screws, and a knob lock that never suited a street entrance.
Call now · open 24/7(249) 800-5180In plain words
A keypad or smart lock is a lock replacement with a few extra steps, and it suits households where keys circulate widely. The locksmith fits the new deadbolt to the existing bore, checks that the bolt throws freely so the motor is never straining against a misaligned strike, sets up user codes and any phone pairing, and shows you the mechanical override and the battery warning. Because these locks still rely on a bolt and a strike, the same attention goes into the frame as for any deadbolt. You gain convenience without giving up the mechanical basics that make a door hard to force.
How the visit goesThe lever on the side door droops toward the floor and rattles in your hand. The latch no longer springs back on its own, so the door drifts open behind you unless you pull it shut and check it twice.
Lock Replacement & Upgrade · Tollendal
How the visit goes

- 1
The rest of the openings
One failing lock is often the loudest of several, so the locksmith takes a short tour. The back door, the garage man-door, a basement walkout, a sliding patio door and a storm door all count, and so does the door from the garage into the house, which is often the lightest lock on the property. Each is noted for grade, condition and whether it has a deadbolt at all. You are not obliged to do them all at once; the value of the tour is a clear list ranked by what matters most, so the first replacement goes where it makes the largest difference.
- 2
Fitting the latch or bolt to the door
Most modern latches and bolts adjust between the two common backsets, so the unit is set to the measured figure and slid into the edge bore. A spring latch goes in with its bevel facing the strike, while a deadbolt is oriented the way its markings or instructions call for, not by that bevel rule. The faceplate should sit flush in its mortise; where the old cut-out differs in shape or size, the mortise is trimmed with a sharp chisel, or a round drive-in collar is used where the door was prepared that way. The bolt is checked to travel freely before anything else goes on, since a bolt that binds in the door will bind under the key too.
- 3
Every lock tried the way you will use it
Before the tools go back in the van, each lock is operated from both sides with the door open, then closed, then closed hard against the weatherstrip. The latch should catch on its own when the door swings shut, the deadbolt should throw to its stop with a fingertip on the thumb-turn and no shoulder on the door, and the key should turn without lifting or jiggling. You are invited to try each one yourself and to lock up behind the locksmith. Anything that felt marginal has been adjusted, so the door you close that night behaves the same as the one you tested.
In the van
- Graded deadbolt
- Chisels, mallet and hand screwdrivers
- Adjustable latch or bolt
- Cylinders, plug follower and pinning kit
- Handleset with matching deadbolt
What affects the quote
- 1
Authorization needed from a property manager or landlord
A rental or condominium unit sometimes needs sign-off from a property manager or landlord before a lock is changed, and new keys may need to reach more than one party afterward. Confirming who is authorized and who receives keys is worked out before the new hardware goes in.
- 2
Keys cut
Each key is counted, and restricted keys cut against a card are a different item from standard blanks. Say how many people need one and the quote lists them.
- 3
Older and mortise hardware
Servicing an original mortise case, sourcing a compatible cylinder or fitting a conversion plate on a century door involves more assessment and fitting time than a standard cylindrical replacement.
Same fees day, night or weekend.
Lock Replacement & Upgrade: questions
What does a higher grade of lock actually give me?
Grades follow ANSI/BHMA standards, with Grade 1 the highest and Grade 3 the lightest, and residential hardware carries a separate label that scores security, durability and finish. The grade reports how the lock performed on the standard's own operational, strength and security tests; a higher grade often comes with a longer bolt, a sturdier housing, pins that resist picking and a strike built to anchor into the framing, but those features are worth confirming on the specific model rather than assumed from the grade alone.
Is it possible to upgrade just the exterior locks now and handle interior doors later?
Yes, and it is a common way to spread the work out. Exterior doors carry the security load, so starting there with a graded deadbolt and a reinforced strike covers the part that matters most first. Interior locks, passage sets, privacy locks on bathrooms and bedrooms, can be scheduled for a later visit without affecting anything already done, and the locksmith can note what was fitted so the second visit matches it.
Will a new lock fit the holes already in my door?
Usually, yes. Most residential doors are prepared to standard sizes, a 54 millimetre cross bore and a backset of 60 or 70 millimetres, and most modern hardware adjusts between those backsets. The locksmith measures before choosing, so the new lock is matched to the door rather than the other way around. Where an older mortise lock or an unusual bore is found, filler plates, extension kits or a carefully jigged new bore bring the door to standard.
Lock Replacement & Upgrade near you
Simcoe, Ontario
Tollendal information
- Town
- Tollendal, Simcoe, Ontario
- In business
- 18 years
- Hours
- Open 24/7 · nights, weekends and holidays, same fees
- Phone
- (249) 800-5180
- Visits
- On-site assessment preferred. Request a visit or call.
What the census means at the door
29%
Newer homes. About 29% of homes in Barrie were built in 1980 or earlier, according to the 2021 Census.
Builder-grade cylinders in newer homes are usually simple to pick and bump. Households who want their door to resist more than a casual try can move to a high-security cylinder that drops into the same hardware they already own.
58%
A mix of homes. Single-detached houses make up about 58% of homes in Barrie (2021 Census).
A mix of detached and attached housing means a mix of key habits: spare keys under pots at houses, fob-and-key combinations in buildings. A locksmith can improve both, with a proper key safe or keypad here and a tidy suite cylinder there.
Open 24/7
Request a visit
The house is fifteen years old and every exterior door still wears the light hardware the builder fitted: a short bolt, a thin strike held by two small screws, and a knob lock that never suited a…
Call now · open 24/7(249) 800-5180- On-site assessment preferred
- Same fees day, night or weekend
- 18 years in business




